Thermal Conductivity of Ceramic Tiles Incorporating Iraqi Porcelanite Waste as a Partial Substitute for Ball Clay
Ishraq Abdalkareem Kalaf ALOGAIDI, Ahmed Hafedh Mohammed MOHAMMED, Khairul Anuar SHARIFF, Hasmaliza MOHAMAD, Muhamed Abdul Fatah Muhamed MUKHTAR
Abstract. This work investigates the effect of partial replacement of ball clay by Iraqi porcelanite waste powder on heat transport and pore related properties of ceramic tiles. Four compositions were investigated: an unmodified control and bodies containing formulations incorporating 1 wt.% (designated as A), 3 wt.% (B), and 5 wt.% (C) of porcelanite. Powder mixtures underwent 24 h milling at 60 rpm, followed by uniaxial pressing under 35 MPa for 5 min. Sintering was then performed at 1200 °C for a 6 h dwell time, using a heating rate of 5 °C/min. Thermal conductivity was interpreted together with water absorption and apparent porosity. Composition A exhibited the lowest conductivity, 1.318 W/m·K, corresponding to a 3.1% reduction relative to the control value of 1.360 W/m·K; it recorded values of 0.97% for water absorption alongside an apparent porosity of 2.44%. The conductivity response was not monotonic with porcelanite content, indicating that heat transfer depended on the combined effects of pore structure, densification, and solid-phase continuity. Within the investigated range, 1 wt.% porcelanite provided the most favourable thermal response, although the improvement was modest. The results support the controlled reuse of Iraqi porcelanite waste in ceramic production while reducing the demand for conventional raw materials.
Keywords
Thermal Conductivity, Ceramic Tiles, Iraqi Porcelanite, Apparent Porosity
Published online 11/15/2026, 7 pages
Copyright © 2026 by the author(s)
Published under license by Materials Research Forum LLC., Millersville PA, USA
Citation: Ishraq Abdalkareem Kalaf ALOGAIDI, Ahmed Hafedh Mohammed MOHAMMED, Khairul Anuar SHARIFF, Hasmaliza MOHAMAD, Muhamed Abdul Fatah Muhamed MUKHTAR, Thermal Conductivity of Ceramic Tiles Incorporating Iraqi Porcelanite Waste as a Partial Substitute for Ball Clay, Materials Research Proceedings, Vol. 74, pp 141-147, 2026
DOI: https://doi.org/10.21741/9781644904473-18
The article was published as article 18 of the book Composite Science and Technology
Content from this work may be used under the terms of the Creative Commons Attribution 3.0 license. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.
References
[1] G.A. Waheed, Assessment using of various sources of silica on the properties of porcelain, Doctoral dissertation, University of Babylon, Babylon, 2022.
[2] H.M. Saleh, Using of porcelinite as coarse aggregate in concrete, Tikrit J. Eng. Sci. 19 (2012) 33-40. https://doi.org/10.25130/tjes.19.3.04
[3] S.I. Ahmed, A.S. Al-Adili, A.M. Hameed, A short review on preparation and characterization of Iraqi porcelanite aggregate concrete, J. Appl. Sci. Nanotechnol. 2 (2022) 49-58. https://doi.org/10.53293/jasn.2021.3565.1028
[4] I. Allegretta, G. Eramo, D. Pinto, A. Hein, The effect of temper on the thermal conductivity of traditional ceramics: Nature, percentage and granulometry, Thermochim. Acta 581 (2014) 100-109. https://doi.org/10.1016/j.tca.2014.02.024
[5] J. García-Ten, M.J. Orts, A. Saburit, G. Silva, Thermal conductivity of traditional ceramics. Part I: Influence of bulk density and firing temperature, Ceram. Int. 36 (2010) 1951-1959. https://doi.org/10.1016/j.ceramint.2010.05.012
[6] S.M. Awadh, L.A. Fadhil, Assessment of porcelanites, western desert of Iraq as aggregates for structural lightweight concrete, J. Babylon Univ. Pure Appl. Sci. 23 (2015) 1636-1652.
[7] Z.H. Naji, H.M. Mubarak, A.M. Ibrahim, Thermal properties of lightweight self-compacting concrete incorporate nano silica, Ann. Chim. Sci. Matér. 48 (2024) 427-434. https://doi.org/10.18280/acsm.480315
[8] M.H. Al-Taie, A.H. Ali, A.F. Al-Attar, Study the physical properties and thermal conductivity of lightweight refractory bricks produced by adding porcelanite to kaolinite, Eng. Technol. J. 33 (2015) 51-60.
[9] Y. Dong, W. Guo, C. Jiang, Y. Shao, L. Zhang, D. Wang, X. Lu, S. Huang, X. Cheng, Using CaO as a modifier agent to optimize the pore structure of foamed ceramics from granite scrap, Ceram. Int. 49 (2023) 13443-13451. https://doi.org/10.1016/j.ceramint.2022.12.219
[10] P.O. Piccolo, A. Zaccaron, L.B. Teixeira, E.G. de Moraes, O.R.K. Montedo, A.P.N. de Oliveira, Development of translucent ceramic tiles from modified porcelain stoneware tile paste, J. Build. Eng. 45 (2022) 103543. https://doi.org/10.1016/j.jobe.2021.103543
[11] Z. Tian, Homogenization of mechanical and thermal properties of fired clay bricks: Effects of porosity, Doctoral dissertation, INSA Toulouse, Toulouse, 2018. https://theses.hal.science/tel-01897937v1
[12] J. García-Ten, M.J. Orts, A. Saburit, G. Silva, Thermal conductivity of traditional ceramics. Part II: Influence of mineralogical composition, Ceram. Int. 36 (2010) 2017-2024. https://doi.org/10.1016/j.ceramint.2010.05.013
[13] I.A. Kalaf, P.R. Nalanakumar, K.A. Shariff, A.H. Mohammed, Effect of Iraqi porcelanite composition on the properties of ceramic tiles: Experimental and simulation works, J. Phys.: Conf. Ser. 2907 (2024) 012023. https://doi.org/10.1088/1742-6596/2907/1/012023

