Tailoring Interfacial Strategies to Enhance Mechanical Properties of Bi-Layered LSR-Based Polymer Composite Radiation Shields

Tailoring Interfacial Strategies to Enhance Mechanical Properties of Bi-Layered LSR-Based Polymer Composite Radiation Shields

Pramod A.C., Ambika, Subramanian K.R.V., Niranjan Murthy, Roopa, Nagaiah N., Sherry Shajan Kuttukaran

Abstract. This study presents the fabrication and evaluation of bi-layered Liquid Silicone Rubber (LSR) composites by incorporating Tungsten trioxide (WO₃) and Antimony (Sb) as fillers, with a particular focus on how interfacial surface treatment affects the mechanical integrity of the bilayer. Two sets of three composite formulations (WOSB1, WOSB2, and WOSB3) were prepared at progressively higher filler loadings, one set with and the other without mechanical surface treatment at the inter-layer interface. The highest-loading formulation, WOSB3, achieved an overall composite density of 2.318 ± 0.069 g cm-3 and proved to be the best-performing of the three. Untreated bi-layer specimens delaminated prematurely at the interface during tensile testing (ASTM D412), showing a characteristic stepwise load drop on the stress-strain curve. For WOSB3, the treatment elevated tensile strength from 0.811 ± 0.03 MPa to 1.398 ± 0.05 MPa and elongation at break from 129 ± 4% to 172 ± 5%. Radiation attenuation measurements for 80 keV gamma rays yielded a Mass Attenuation Coefficient (MAC) of 2.884 ± 0.105 cm2 g-1 for WOSB3, surpassing the MAC of conventional lead (2.312 cm2 g-1) at the same energy.

Keywords
Bi-Layer Composite, Interfacial Adhesion, Gamma Radiation Shielding, Tensile Properties, Surface Engineering

Published online 11/8/2026, 6 pages
Copyright © 2026 by the author(s)
Published under license by Materials Research Forum LLC., Millersville PA, USA

Citation: Pramod A.C., Ambika, Subramanian K.R.V., Niranjan Murthy, Roopa, Nagaiah N., Sherry Shajan Kuttukaran, Tailoring Interfacial Strategies to Enhance Mechanical Properties of Bi-Layered LSR-Based Polymer Composite Radiation Shields, Materials Research Proceedings, Vol. 73, pp 229-234, 2026

DOI: https://doi.org/10.21741/9781644904459-44

The article was published as article 44 of the book Mechanics of Advanced Materials and Structures

Content from this work may be used under the terms of the Creative Commons Attribution 3.0 license. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.

References
[1] Podgorsak, E. B. (2016). Radiation Physics for medical physicists. In Graduate texts in physics. https://doi.org/10.1007/978-3-319-25382-4
[2] International Commission on Radiological Protection (ICRP), “The 2007 Recommendations of the International Commission on Radiological Protection,” ICRP Publication 103, Ann. ICRP, vol. 37, nos. 2–4, 2007.
[3] Nambiar, S., & Yeow, J. T. W. (2012b). Polymer-Composite materials for radiation protection. ACS Applied Materials & Interfaces, 4(11), 5717–5726. https://doi.org/10.1021/am300783d
[4] Safari, A., Rafie, P., Taeb, S., Najafi, M., & Mortazavi, S. M. J. (2024). Development of Lead-Free Materials for Radiation shielding in Medical Settings: A review. Journal of Biomedical Physics and Engineering, 14(3), 229–244. https://doi.org/10.31661/jbpe.v0i0.2404-1742
[5] Kuttukaran, S. S., Ambika, M. R., Siddaraju, C., Nagaiah, N., Srilakshmi, B. P., Reddy, Y. H., Goel, P., Kimothi, S., Ganguly, D., Chattopadhyay, S., & Roopa, S. (2025). Fabrication and investigation of a novel bi-layered, silicone rubber-based composite as a promising radiation shield. Journal of Radioanalytical and Nuclear Chemistry, 334(10), 7459–7471. https://doi.org/10.1007/s10967-025-10216-w
[6] Comyn, J. (1997). Polymer science dictionary 2nd edition. International Journal of Adhesion and Adhesives, 17(4), 381. https://doi.org/10.1016/s0143-7496(97)00015-8
[7] ASTM D412-16, Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension. West Conshohocken, PA, USA: ASTM International, 2016.
[8] Srilakshmi, B. P., Reddy, A. J., Ambika, M. R., Kuttukaran, S. S., Reddy, Y. H., Nagaiah, N., Deepika, D. N., & Prashantha, K. (2025). Exploration of the gamma-ray shielding capabilities of tungsten oxide and chromium-infused silicone rubber composites. Radiation Physics and Chemistry, 232, 112661. https://doi.org/10.1016/j.radphyschem.2025.112661
[9] Connolly, J. V. (1984). Structural adhesive joints in engineering. Robert D. Adams and william C. Wake. Elsevier applied science publishers, london. 1984. 309pp. Illustrated. £35.00. The Aeronautical Journal, 88(877), 329–329. https://doi.org/10.1017/s0001924000020777
[10] Park, H., & Lee, S. H. (2021). Review on Interfacial bonding mechanism of functional polymer coating on Glass in Atomistic Modeling Perspective. Polymers, 13(14), 2244. https://doi.org/10.3390/polym13142244
[11] Awaja, F., Gilbert, M., Kelly, G., Fox, B., & Pigram, P. J. (2009). Adhesion of polymers. Progress in Polymer Science, 34(9), 948–968. https://doi.org/10.1016/j.progpolymsci.2009.04.007
[12] Guth, E. (1945). Theory of filler reinforcement. Journal of Applied Physics, 16(1), 20–25. https://doi.org/10.1063/1.1707495
[13] Smith, W. R. (1967). Reinforcement of elastomers. Gerard Kraus, Ed. Interscience, New York, 1965. xv + 611. Journal of Applied Polymer Science, 11(10), 2079–2079. https://doi.org/10.1002/app.1967.070111026