Effect of chloride concentration on carbon steel corrosion of boilers supplied with feed water in refineries
Abeer ALFARHAN, Abdulmuhsen AKBAR
Abstract. Corrosion has a significant economic and environmental impact in most of the oil sector facilities. One of the most widely used materials in these facilities is carbon steel. The corrosion of carbon steel caused by dissolved carbon dioxide (CO2) has been recognized to pose a serious threat to the oil and gas industry. Numerous factors affect CO2 corrosion including temperature and water composition. Effects of temperature and Cl- concentration on the corrosion behavior of carbon steel in CO2-saturated environments were investigated for boiler used in refineries supplied with feed water of certain composition with different Cl- concentration. Corrosion rate was measured using electrochemical linear polarization method. The purpose of this study is to investigate the effect of chloride concentration on the final corrosion rate of refinery boiler made of carbon steel supplied with feed water at two different temperature. The study found that the corrosion rate decreased with the increase of Cl- concentration and that decrease was more significant at 30°C. At 30°C, initial corrosion rate was 1.18mm/yr., and was reduced to 0.041mm/yr. at Cl- concentration of 1000mg/l while at 45°C, initial corrosion rate was 0.885mm/yr., and was reduced to only 0.478 at Cl concentration of 1000mg/l. These results could be explained by the reduced penetration of CO2 gas caused by the higher Cl- concentration.
Keywords
Corrosion, Carbon Dioxide, Chloride Concentration, Boiler, Temperature
Published online 2/25/2025, 7 pages
Copyright © 2025 by the author(s)
Published under license by Materials Research Forum LLC., Millersville PA, USA
Citation: Abeer ALFARHAN, Abdulmuhsen AKBAR, Effect of chloride concentration on carbon steel corrosion of boilers supplied with feed water in refineries, Materials Research Proceedings, Vol. 48, pp 729-735, 2025
DOI: https://doi.org/10.21741/9781644903414-79
The article was published as article 79 of the book Civil and Environmental Engineering for Resilient, Smart and Sustainable Solutions
Content from this work may be used under the terms of the Creative Commons Attribution 3.0 license. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.
References
[1] U. Bharatiya, P. Gal, A. Agrawal, M. Shah, A. Sircar, “Effect of Corrosion on Crude Oil and Natural Gas Pipeline with Emphasis on Prevention by Ecofriendly Corrosion Inhibitors: A Comprehensive Review,” J. Bio- Tribo-Corrosion 5 (2019). https://doi.org/10.1007/s40735-019-0225-9.
[2] W. Faes, S. Lecompte, Z.Y. Ahmed, J. Van Bael, R. Salenbien, K. Verbeken, M. De Paepe, “Corrosion and Corrosion Prevention in Heat Exchangers,” Corrosion Reviews 37 (2019) 131–155. https://doi.org/10.1515/corrrev-2018-0054
[3] B.N. Popov, “Basics of Corrosion Measurements,” in: Corrosion Engineering (2015). https://doi.org/10.1016/b978-0-444-62722-3.00005-7
[4] Al-Khalifa, M. A., Cox, R. L., & Saad, H. Electric Submersible Pump Installation and Commissioning – Challenges and Lesson Learned from Field Development. Society of Petroleum Engineers. 2015; 10.2118/177990-MS.
[5] Z. Zhang, Z.-f. Hu, L. He, X.-b. Zhang, X.-x. Fang, B.-s. Zhang, Z.-x. Ba, “Effects of chloride on electrochemical and stress corrosion cracking behavior of 9Cr ferritic–martensitic steel,” J. Iron Steel Res. Int. 27 (2020) 719–731.
[6] H.S. Abdo, A.H. Seikh, J.A. Mohammed, M. Luqman, S.A. Ragab, S.M. Almotairy, “Influence of Chloride Ions on Electrochemical Corrosion Behavior of Dual-Phase Steel over Conventional Rebar in Pore Solution,” Appl. Sci. 10 (2020) 4568.
[7] Z. Sanaei, Bahlakeh, G., Ramezanzadeh, B., & Ramezanzadeh, M. (2019). Application of green molecules from Chicory aqueous extract for steel corrosion mitigation against chloride ions attack; the experimental examinations and electronic/atomic level computational studies. Journal of Molecular Liquids, 290, 111176. https://doi.org/10.1016/j.molliq.2019.111176
[8] Schmitt, G. (2015). “Fundamental aspects of CO2 metal loss corrosion. part ii: influence of different parameters on CO2 corrosion mechanism,” in Corrosion (2015). Conference and Expo (Houston, TX: NACE International).
[9] H. Fang, Brown, B., and Nesic, S. (2013). Sodiumchloride concentration effects on general CO2 corrosion mechanisms. Corrosion 69, 297–302. doi: 10.5006/0222.
[10] Han, J., Carey, J. W., and Zhang, J. (2011). Effect of sodium chloride on corrosion of mild steel in CO2-saturated brines. J. Appl.Electrochem. 41, 741–749.doi: 10.1007/s10800-011-02903.